A few months ago I wrote a post about the IKEA hack with a commode for our nursery. You can read it here. Besides the commode we also wanted a little closet/storage bench for toys and chose the STUVA storage bench. Because the wall where it would stand against is white, we didn’t wanted a fully white one. We chose to use a underlayment front, just like we did with the commode.
NL
Een paar maanden geleden schreef ik een blog over de IKEA hack met een commode voor onze babykamer. Je kunt de blog hier lezen. Naast de commode wilden we ook graag een lage kast/lade voor speelgoed en kwamen we uit op de STUVA bank met bergruimte. Omdat de muur waartegen we de bank wilden plaatsen wit is, wilden we niet een geheel witte. We kozen er daarom voor om net als bij de commode een frontje van underlayment te maken.
This is the result! Because we decided not to adopt the size of the original front of the drawer, it was a real job to measure all the holes exactly to fit the original closet. After that we made a round hole in the middle of the drawer, just like we did with the commode, so it matches each other.
Dit is het resultaat! Omdat we besloten de afmetingen van het originele frontje niet helemaal over te nemen, was het nog wel even een klus om alle gaten voor de schroeven goed af te meten, zodat het frontje precies op de rest van de lade past. Daarna hebben we net als bij de commode geen knopje gebruikt als handvat, maar een gat geboord, zodat het mooi bij elkaar past.
But the project wasn’t finished yet! Personally I don’t always love the use of wood on wood. Like here the combination of the wooden drawer and the floor. That’s why I searched for a solution to break this wood on wood thing. I saw a lot of nice ideas on Pinterest, such as decorations with paint on wood, which inmediately gives a playful effect! First I drew the patterns on paper and cut it out so I could rearrange them until I was satisfied.
Maar toen was ik nog niet klaar! Hout op hout vind ik persoonlijk vaak niet zo mooi. Zoals hier de houten lade op de laminaatvloer. Daarom ben ik op zoek gegaan naar iets waarmee ik dat kon doorbreken. Op Pinterest zag ik allerlei leuke ideeën voorbijkomen, waaronder versieringen met verf op hout, wat ook meteen zorgt voor een leuk speels effect! Ik heb eerst de vormen op papier gezet en uitgeknipt zodat ik wat kon schuiven tot ik het gewenste patroon voor me had liggen.
Because I am pregnant I didn’t want to use paint. That’s why I used white plastic foil. I applied the paper patterns on the foil to cut them out in the right size. I numbered the paper patterns first, so I could easily put them back in the right sequence.
Omdat ik zwanger ben en liever niet wilde verven, heb ik mat witte plakfolie gebruikt. De uitgeknipte papieren vormen heb ik op het folie geplakt om ze vervolgens in de juiste maat weer uit te knippen. Ik heb wel eerst de vormen genummerd, zodat ik ze weer makkelijk op de gekozen volgorde kon neerleggen.
The foil sticks very well and almost gives the same effect as paint. A benefit of this plastic foil is that when I want something else, I can easily remove and replace it for another nice pattern!
Het folie blijft goed plakken op hout en geeft bijna hetzelfde effect als verf. Een voordeel van plakfolie is dat wanneer ik iets anders wil, ik het makkelijk kan verwijderen en eventueel kan vervangen voor een ander leuk patroon!
José